
Tire pressure monitoring system lights that refuse to go out in your Volkswagen Jetta even after air has been added to all tires and the system has been reset often have a simple cause that can be found by someone with basic diagnostic knowledge and typical tools.
Start With the Air
So before you even attempt to reset your Tire Pressure Monitoring System, go ahead and check all of your tires for the correct air pressure when they are cold.
The contraction in air pressure in cold temperatures is often the only reason you will find your TPMS light to be illuminated in the morning after being outside in cold weather.
Re-check your tire pressure against the advised pressure as found on the sticker on the inside of your driver’s side door. This number is almost always different from the tire’s sidewall listed pressure and must be used to set your Jetta’s tire pressure. Until you’ve got all of your tires at the correct pressure the system won’t hold a tire pressure reset reading.
How the Reset Works
Indirect systems such as those used in many Jettas do not have wheel sensors, but rather use the ABS to determine the rotational speed of each wheel. This information is then used to help determine if a tire is underinflated. Once you have set the new tire pressure for your tire(s), you must enter the new information into your Jetta’s on-board computer by accessing your vehicle’s settings through various buttons on your dashboard. Note that once you have entered this information, your Jetta’s system will recalculate and relearn your new tire’s characteristics.
When the Reset Won’t Hold
You thought you had done everything right, yet the light is still there. Typically, this can mean one of the following items:
- A slow leak dropping one tire again between fill-ups
- A nail you haven’t found yet
- Uneven pressures the system keeps flagging
On vehicles with sensors inside the tires, all of the sensors need to have good batteries. Dead sensors will illuminate the dashboard warning light and no amount of air will make the pressure light go out because the sensor itself is the problem.
The most common issue, however, is a slow leak. This occurs when a tire is “full” of air, but as the car is driven, the pressure slowly drops off overnight. Then the next day the tire light will come back on. This type of leak cannot be fixed with a simple tire reset, as the problem is the tire itself losing pressure.
Direct or Indirect
The indirect system has no sensors to fail. So, the only factor is the tire pressure and the reset process. Vehicles equipped with direct systems have sealed, battery-powered sensors in the wheels. These sensors typically last for several years. A failed sensor illuminates a warning indicator on your dash. In these cases, no amount of tire inflation or resetting the system will remove the warning light as the sensor is faulty and the system is relying on it for accurate readings.
Tire Light Still On? We can diagnose whether the problem is with the air in your tires, a slow leak, or with one of your tire sensors at Driven Auto Care of Castro Valley. Contact us to schedule an appointment today.








